Art PROSPLIT Transformer Isolated Mic Splitter

Availability: Out of Stock


  • Switchable low cut filter.
  • Variable impedance control.
  • Adds 20dB of gain.
  • Runs off Phantom power supply.
  • Low THD discrete circuitry.
  • Balanced outputs.

The Art ProSplit provides one direct output and one transformer isolated output from a single microphone. Applications include sending the direct output to the main or Front-of-House mixer, with the second isolated output being sent to a monitor or recording mixer. The direct output passes phantom power from the main mixer to the microphone for use with condenser microphones.

The ProSplit includes a ground-lift switch on the isolated output to reduce noise due to ground loops between connected equipment. For versatility the ProSplit also features an attenuator pad switch on the input that can be used to alternately connect a pre-amplified (line-level) signal to the two microphone-level ProSplit outputs.

Product Specification:

Frequency Response: 20Hz to 20kHz, ±0.25dB @ -15dBu [email protected]

Total Harmonic Distortion: <0.26% from 20Hz to 20kHz, -15dBu input, <0.1% from 45Hz to 20kHz, -15dBu input, 0.002% Typical @ 1kHz, -15dBu input

Phase Shift: <10 degrees @ 20kHz (Ref, 1kHz)

Input Impedance: >1.1k Ω @ 1kHz (Typical driving source impedance is 150 Ω)

Ouput Impedance: <255 Ω @ 1kHz (Typical output load impedance is 1k Ω)

Maximum Input Level: -1.4dBu @ 20Hz/+3.5dBu

CMRR: >105dB @ 60Hz / >80dB @ 3kHz

Insertion Loss: Approximately 2dB @ 1kHz

Maximum Input Level For 1% THD: -1.4dBu @ 20Hz/+3.5dBu @ 30Hz / +9.4dBu @ 50Hz

Dimensions: 1.85″ H x 4.6″ W x 3.5″D (47mm x 117mm x 89mm)

Weight: 0.9 lbs (0.4 kg)

More Information
Manufacturer Part Number PROSPLIT
Condition new
width 0
length 0
height 0